Description: Divider is a circuit within the speaker device, different bands (treble, bass) sound signal to distinguish, respectively, to the amplification, and then sent to the corresponding band of speakers and then replay. The workmanship is fine and the material is very exquisite, with a little error of 3%. The process is much more difficult than a core inductor core inductance. The PCB base adopts the fireproof board only, it is clear and clean, the corner of the circuit is rounded, and the thick copper layer can withstand more current. The low frequency part reaches the output port through inductance, so as to achieve clear and full effect. The design is reasonable, the appearance is exquisite, and the sound quality is improved. A wonderful tool for you to use this amplifier on your car, motorcycle, golf cart and other places, where you need small amplifier in order to have a better listening experience. Specification: Material：Alloy Size: Approx. 86 * 63* 25 mm / 3.39 * 2.48 * 0.98 inch Maximum power: 160W Frequency response: 45Hz～20kHz Applicable impedance: 4～8Ω Applicable: 10 inches speakers or less (including 10 inches) Package Includes: 1 Piece Frequency Divider : Please allow slightly difference due to manual measurement. Color may be slightly different since different monitor. Thanks! Note: Due to the light and screen setting difference, the item's color may be slightly different from the pictures. Please allow slight dimension difference due to different manual measurement.