Description: Instructions for RF Wireless RemoteTurn On/ StandbyPress this key to turn on unit or switch to standby mode. Unit will turn on and to previous status at powering on moment.Lighting modeSwitch to lighting mode from dynamic mode.8/9. Dimmer Adjust ShortcutsSwitch to 100%, 50%, or 25% brightness lighting mode.4/6. Dynamic Mode AdjustSwitch to dynamic mode from lighting mode, or switch between different dynamic modes.5/7. Speed AdjustAdjust playing speed of dynamic modes. Press SPEED+ to increase and press SPEED- to decrease.10/11. Brightness Adjust (Dimmer)Adjust lighting mode brightness. Press BRIGHT+ to increase brightness and press BRIGHT- to decreaseFunctions for RF Wireless RemoteDimmer & Dynamic8 Dynamic Effects10-level Dimmer256-Grade PWMSpeed AdjustableCard Type Remote Slim DesignSmooth Dimmer Effect1 to 1 Remote PairedAuto Save FunctionInstalling for RF Wireless Remote1. Power SupplyThis unit accepts DC 5V to 24V power supply.The red cable should be connected to positive and black cable to negative.Please select proper power supply according to the LED application.LED OutputThe red cable should be connected to LED positive and black cable to negative. The peak output current is 12A, please reduce load if main unit is overheating.CAUTION:Do not short circuit the LED output, this may to permanent damage!Remote ControlPlease pull out the insulate part before using. The RF wireless remote signal can pass through barrier, so it's not necessary to aim at the main unit when operate. For proper receiving remote signal, do not install the main unit in closed metal parts.Note: The remote battery is 3V CR2025 type (not included) Specification: Material: PlasticSize: Approx.