Feature: 1. OF SHARPNESS AND SMOOTH CUTTING: Adopt diamond blade, bring of sharpness and smooth cutting, wear resistance is 50‑80 times that of alloy tools 2. CHAMFERED TAIL: The bit body adopts 45 steel, the tail is chamfered, which is more convenient to clamp, and can effectively prevent the bit from breaking 3. HEAD PROTECTED BY SEALING WAX: The cutter head is protected by sealing wax, strong and beautiful, more durable to use 4. FOR VARIOUS WOOD MATERIALS: Suitable for solid wood board, silicic acid board, multi layer board, density board, non fold special board, particle board, rosewood board, MDF 5. FOR FULLY AUTOMATED CNC EQUIPMENT: 45° chamfer bit can be used for all fully automated CNC equipment with 12.7mm shank diameter Specification: Item Type: 45° Chamfer Bit Shank Material: 45 Steel Blade Material: Diamond Product Model: 1/2x1/2x2T Product Diameter: Approx. 31.96mm / 1.26in Bevel Angle: 45° Oblique Width: Approx. 12.7mm / 0.5in Shank Diameter: Approx. 12.7mm / 0.5in Uses: Solid wood board, silicic acid board, multi layer board, density board, non fold special board, particle board, rosewood board, medium fiber board Suitable for all fully automated CNC equipment with 12.7mm shank diameter . Package List: 1 x 45° Chamfer Bit Note: 1. In order to avoid the tool from twisting due to excessive pressure, all tools are designed to rotate CW.2. When the tools are finished, they all pass the balance test to ensure that there is no doubt about runaway. In order to ensure that the tools are free from swing and runout during use again, please pay attention to choosing suitable mechanical equipment and excellent chucks.3. The chuck must be of a suitable size. If it is found that the chuck is not round enough or worn, it will cause the chuck to not be able to clamp the tool properly and correctly. Please replace a good chuck with standard specifications immediately.4. The installation of the tool shank should be in accordance with EU regulations, such as the clamping depth of the 12.7mm shank diameter must reach 24mm in order to maintain the proper pressure bearing range of the tool shank5. When the tool is blunt, please replace with a new one, do not continue to use, so as to avoid tool breakage and work injury6. When using a tool, please select a tool whose blade length is greater than that of the workpiece7. Please allow tiny size error due to manual measurement. Please take the real one as standard.