Note: The chassis switch cable and chassis reset cable are the same; the lettering on the back of the product is consistent with the word POWER. Easy-Touch ATX Chassis Power Switch Cable Application: ATX architecture computer, POWER switch and RESET restart switch Push-button switch, suitable for POWER switch and RESET restart switch, etc. One end is inserted into the POWER socket on the motherboard, and the other end of the switch can be connected to the chassis panel. How to Use: 1. Insert the marked POWER end into the corresponding pin on the motherboard; 2. Connect the switch clip to the chassis panel, and it's ready to use. When the computer case is used for a long time, the Power and Reset buttons may fail, resulting in errors such as failure to start and repeated restarts. This type of cable is used for power supply and reset, and the entire cable is approximately 55 cm long. Some chassis can only be replaced after disassembly, and you need to have a certain ability to do so. If you don't understand, please find an expert to replace it. Do not disassemble it roughly to avoid unnecessary losses.