1. All modules in this store must first be connected to the input end (RFIN) and the output end (RFOUT) and then supplied with power (DC) (connect the DC power supply). 2. If the module is powered by DC power, ensure that the positive and negative DC poles are connected correctly. Do not reverse the connection! Otherwise, the module will be ! 863MHz-873MHz Ultra-Low Noise Amplifier Module Note: Connect the input signal and output load before use. Bandwidth: 863MHz-873MHz Power supply: 3V-5V/55mA NF: Less than 0.6dB (typical value) Maximum input power: ≤0dBm Maximum output power: 100mW (20dBm) Gain: As shown in the list below Input and output impedance: 50Ω Input voltage Vpp: Less than 0.225V Housing: CNC precision machining Connector type: SMA female (external thread, inner hole) Size: 33mm x 21mm x 10.5mm (without connector) Instructions for use: RFin is the signal input Connection RFout is the signal output connection. GND is the negative terminal of the DC power supply. DC is the positive terminal of the DC power supply. Specification: 5V Color: As Shown Material: Aluminum Alloy Package Contents: 1 * Low Noise Amplifier Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.