BLTouch Style Leveling Sensor Kit

High-fidelity BLTouch-compatible auto bed leveling sensor kit built for precision and cross-platform reliability. Physical specs: white translucent PC housing, 50g weight, 5V DC input, 15mA operating current (300mA peak). Comes with two pre-terminated leads — 200mm short cable for compact builds and 1000mm long cable for versatile mounting. Standardised 3-pin interface (Green=GND, Red=5V, Orange=Signal) plus separate 2-pin Z-min switch (Black=GND, White=Zmin) simplifies connection to most 3D printer control boards. Uses progressive solenoid actuation combined with Hall effect sensing to achieve sub-0.01mm repeatability in probe triggering. Delivers accurate bed surface mapping by making physical contact at up to 16 configurable grid points — feeding real-time Z-offset data to firmware for dynamic layer compensation. Enables stable first-layer adhesion on warped, bowed or poorly mounted beds — significantly reducing manual levelling frequency. Tested and verified for Ender-3, Ender-3 S, Ender-3 Pro, Ender-3 V2, Ender-5, CR-10 series (including CR-10S, CR-10S4, CR-10S5), CR-20/Pro, Ultimaker 2, Kossel, BLV, Voron and Anycubic printers. Not supported on Creality mainboards newer than v4.2.7 due to changed Z-min circuit architecture.