Universal Ceiling Fan Lamp Remote Control Kit AC 220V Timing Setting Switch Adjust Wind Speed Caution: When the new device cannot be remote controlled, check whether the bar codes in the emitter and receiver match, whether the indicator light on the emitter is working, whether the receiver cables are properly connected, and whether the buzzer beeps once when powered on. If the receiver cannot be controlled by the emitter, check whether the battery contacts are normal and whether the battery has sufficient power. Replace the battery promptly when it is low. Insensitive remote control may be due to environmental interference or low battery. Remove the battery if the device is not used for an extended period. Wire the device strictly according to the parameters labeled. Incorrect wiring may shorten the device's lifespan or cause immediate malfunction. The antenna must not be connected to other wires. If there is a code switch on the fan, set the fan to the highest speed before remote operation. The receiver beeps when the remote is pressed, which may be noticeable. Ensure sufficient space in the fan canopy or install the receiver nearby. Operating Voltage: AC 90–220V Working Frequency: 50–60Hz Remote Control Distance: More than 20 meters Support Encoding: 1527 learning code Operating Mode: 1527 remote control Load Capacity: - Ceiling Fan: Max 300W - Incandescent Lamp: Max 1000W - LED / Energy Saving Lamp: Max 200W Do not exceed the maximum load. Remote Control Battery: 2 x AAA batteries required (not included) Type: 220V Color: White + Black Material: Plastic Package Contents: 1 x Controller 1 x Remote Control 1 x Wall Bracket Only the items listed above are included; other products are not included. Note: Lighting and display differences may cause slight color variations between the image and the actual item. Measurement error is allowed within +/- 1–3 cm.