Function: 1. Longer length and blade more forward, save effort when thinning hair. 2. Longer handle and thicker place to hold, more exquisite and reasonable design for comfortable grip. 3. The delicate workmanship of the blade makes it more convenient to use and ensures high performance. 4. Made of high quality stainless steel material blades, effectively resistant to oxidation, prevent rust and have a long service life. 5. Including hair thinning comb and 10pcs pack blades, meeting your requirements and convenient to replace the blade. Specification: Item Type: Hair Thinning Comb Material: stainless steel/ABS Total length: ok. 19 cm / 7,5 inch Comb handle: ok. 12 cm / 4,7 inch How to install the blade: (1) Push the blade firmly towards the head (2) Move to the fixed position of the block and remove the module up (3) After replacing the blades, arrange them back in the correct order Use: 1. Choose your hair: comb from the front to the edge of your hair, lighten your comb teeth, comb up and don’t let short hair fall out. When the edge appears jagged, straighten it directly with the comb handle, then stop it backwards za clips and divide the rest of the front hair into two parts. 2. Decide on the length: After determining the length, the hair on the forehead can be cut with a knife from the center of the forehead at an angle of 30 degrees, although cut according to the center of the length, if it is too close to the center, it will be longer, so be careful when cutting. 3. When divided into two parts, trim the upper part of the hair opposite each other so that the sections are aligned. 4. With your fingers, divide the hair into three to four parts, starting at an angle of 30 degrees, about 3-4 cm from the tip of the hair. Cut the hair at the ends 3-4 times. List of packages: 1 x Hair Thinning Comb 10 x Blade