DC10G DC10K Multi-Function Generator Controller with Manual Start/Stop for Engines, CE Certified

New DC10K Engine Manual Start Controller with Hz, Volt, Battery Voltage, and Accumulation Time Display for Generator Set 12006022 Features: The DC10K controller is designed as an engine manual start controller. It displays frequency, voltage, battery voltage, and accumulated running time via the front LED screen. The unit provides multiple alarm and stop indications to monitor generator set status. It can be connected to a PC for parameter configuration, allowing compatibility with various generator sets. Panel Introduction: 1. Indicators: - Generator frequency - Generator voltage - Battery voltage - Accumulated running time - Emergency stop - Over/under speed - Low oil pressure - High water temperature - Charging abnormal - Over voltage Notes: 1) Over-speed value will flash on the display after an over-speed alarm. 2) Over-voltage value will flash on the display after an over-voltage alarm. 3) Charging failure triggers an alarm indication but does not stop the engine. 2. Buttons: Display buttons: Four status switches for viewing generator voltage, generator frequency, battery voltage, and accumulated time. Press and hold the PAGE button for more than 5 seconds when the module is powered on and in stop mode to switch between 50Hz and 60Hz. Operation: 1. Power On: Switch from position 0 to I until the indicator lights up. During cranking, if the start is unsuccessful after 45 seconds, the over-speed indicator will light up. The controller will cut off the fuel solenoid output and enter protection mode. 2. Start Running: Switch from position I to II to start the engine. Once powered, the engine begins cranking. If cranking is successful, the controller enters running status after 8 seconds and monitors operational parameters with protective functions. If the generator set stops, the controller will cut off the fuel solenoid output and display the alarm status. Return the switch to position 0. 3. Stop and Reset: Switch from position I to 0 to stop and remove power. Parameter Setting: Connect the module to a PC using a communication cable and power on the unit. 1. Alarm Settings: - Over-speed alarm: 1710 RPM (for 50Hz rated), 2040 RPM (for 60Hz rated), adjustable range: 0–4000 RPM. Alarm and stop if exceeded for more than 1 second. - Over-frequency alarm: 57 Hz (50Hz system), 68 Hz (60Hz system), range: 40–80 Hz. Alarm and stop if exceeded for more than 1 second. - Low-frequency alarm: 20 Hz, range: 20–60 Hz. Alarm and stop if below threshold for more than 5 seconds. - Over-voltage alarm: 265 V, range: 50–500 V (500 V is disabled). Alarm and stop if exceeded for more than 5 seconds. - Charging failure (D+ to B+): 6 V, range: 1–24 V. Alarm if differential voltage exceeds set value for more than 5 seconds. 2. Display Settings: - Four-screen auto-cycling display: Parameters rotate based on set interval time. - Homepage option: Set one parameter as the default home screen. Screen changes automatically when the page button is pressed and held. - Revert-back delay: Time to return to home screen. - Self-cycling display time: Interval setting for screen rotation. Technical Specifications: - Power supply: 8–33 VDC - Power consumption: Max 2 W (working) - Alternator voltage input: 15–300 VAC, 50/60 Hz - Speed input frequency: 300 Hz to 10 kHz - Fuel output: Max 16 A - Start output: Max 10 A - Excitation output: Max 80 mA - Alarm output: Max 16 A - Operating temperature: -30°C to +75°C - Storage temperature: -40°C to +85°C - Dimensions: 78 x 78 x 72 mm - Panel cutout: 67 x 67 mm - Weight: 280 g