Temperature and humidity parameter settings:Test: After connecting the components as shown in the figure, turn on the power, you will hear the alarm sound caused by temperature and humidity, and manually cancel the alarm.adjust the temperature and humidity, change the number of hatching days: Press the Set button, press "+/-" to select the desired temperature, set the humidity and incubation days in the same operation (repeated twice) and finally tap the setting to exit setup. (Note: The factory setting is 37.8 Celsius, you can set 37.6 Celsius according to the above method. After setting the hatching days, the machine reboots.)low or high temperature alarm parameter setting: press the setting button for 3 seconds, press "+/-", the display will show "AL", press "+/-" to select the low temperature parameter. Press the setup button for 3 seconds, the display shows "AH" and the high temperature alarm parameter is set as above.Humidity alarm parameter setting: the humidity parameter is set to 45% when done and does not need to be reset. (If you need to configure it according to the temperature parameter setting mode, the display shows "how").Calibration of the temperature sensor report: the normal temperature report is set to 0 Celsius. If not correct, the adjustment can be made. The method is the same as above, and the display shows CA ".)the upper temperature or lower limit: If HS (maximum limit set) is set to 38.2 and LS (lower limit set) is 37.4, the temperature can only be changed from 38.2 to 37.4, and the lower limit must be 37.2.Heating elementssettings:The HU and HD parameters are set by the factory and do not need to be reset. (as shown)Bullet points:1.Mini DIY incubator accessories2 fan exhaust fan uses evenly for a long time, silent incubation3.incubator PTC heating plate, automatic constant temperature, energy saving4.Humidity Probe: imported digital humidity sensor, long-term product performance and stable performance.5.designed for artisanal incubatorPlug Type:EU Plug,it applies to Indonesia, Germany, France, Spain, Italy and so onSpecifications:Name: Mini DIY incubator accessoriesModel: HTMC-5Nominal power: 80 WNominal voltage 220 VTurning Egg Frequency: 2H / hourTemperature control range: 37 Celsius ~ 39 CelsiusScope of application: 48, 56, 96, 112Colour:BlackMaterial:plasticSize:About 33.2*3*10.2cmPackage Contents:1*electricity-powered fan1*heated board1*EU plug1*panel1*humidity probe1*temperature probe1*motor interface1*egg motorOnly the above package content, other products are not included.Note: Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.