Features: 1. Specially designed for RC cars with excellent starting, acceleration and linearity characteristics. 2. Compatible with brush motor, very practical. 3. With strong current resistant performance, excellent heat dissipation. 4. With multiple protection functions such as low voltage cut-off protection for lithium or nickel battery / overheating protection / throttle signal loss protection. 5. Easy to program and compatible with pocket program card. Specification: Cont. Current/Burst Current: 60A/320A Motor Type: Brushed Motor Suitable for Car: 1/10 Battery: 2-3 Lipo Cells.4-9 NiMH Cells BEC: 5V/2A (Switching Mode) List Package Contents: 1 * Electronic Speed Controller Instructions: 1. Connect the BEC wires to the receiver. 2. Connect the motor wires with ESC. 3. Turn on the transmitter. 4. Connect the battery with the ESC then turn on the ESC. 5. When the connection of the motor and battery is completed, the motor will beep again. 6. When the throttle is in the neutral position, the engine will beep again. 7. The ESC is functional. Troubleshooting Guide: 1. If the motor cannot run after power on and no sound is heard, please check the connections between the battery and the motor. 2. If the engine only beeps, please check all connections: BEC wires, transmitter and receiver, throttle signal wires, etc. Please check the TH.TRIM transmitter and adjust it to the motor that emits the beep sound again. 3. If the car cannot accelerate, please check the battery voltage is too low or the ESC temperature is too high. If the battery voltage is too low, please replace the battery. If the ESC temperature is too high, please check all connections. Otherwise, please press the EPA button on your remote control. 4. If the car suddenly stops in running condition, please check the engine connections and road block. 5. If the car is driving in reverse, the transmitter is available. Please swap two wire connections between the ESC and the motor. 6. Set the ESC: The ESC uses the jumper cap to set the battery type.