Extended reach reduces bending and makes floor cleaning easier for everyone. Fully extended length is 60 inches (150 cm) and is 49 inches (123 cm) when not fully extended, allowing short, tall, and extra tall users to clean floors comfortably without strain. Thickened and reinforced for long-term use. Made from thickened premium stainless steel and ABS plastic, this spin mop handle replacement parts set is sturdy and built for durability. Easy to use with a twist and release locking system. Suitable for both new and used spinning mops. To operate: open the latch before rotating, align the mop with the protruding part, and push the handle up and down to clean and rotate the mop. Easy to assemble. The rotating mop chassis has an outer diameter of approximately 6.5 inches (16.5 cm) and an inner diameter of approximately 6.3 inches (16 cm), allowing flexible assembly or disassembly. See the details page for installation steps. Compatibility and use cases. This is a replacement mop handle for spin mops, designed to fit standard spin mop components with the described dimensions, ensuring a secure fit for continued use. 2-3 practical use scenarios - Cleaning under low furniture and beds: the extended length helps you reach tight spaces without bending. - Large-area floor cleaning: cover more surface with less effort in kitchens, living rooms, and hallways. - Revitalizing an existing spin mop: swap in this reinforced handle to extend the life of your mop setup.