PDB: Input voltage range: 9~30V (3~6S LiPo) with protection<br>Current Senor: 220A, 3.3V ADC (INAV scale 150, 66.7A/V)<br>Sense resistor: 100A continuous, 220A <br>Battery Voltage divider 1K: 10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in )<br><br>MCU: STM32F405RGT6, 168MHz , 1MB Flash<br>IMU: ICM42688-P<br>Baro: DPS310<br>OSD: AT7456E<br>: Micro-SD card slot<br>6x UARTs, 1x Softserial_Tx option(INAV)<br>10x PWM outputs<br>2x I2C<br>3x ADC (VBAT, Current, RSSI)<br>Built in inverter for SBUS input<br>USB Type-C(USB2.0)<br>BEC 5V output: <br> controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed<br>Continuous current: 2 Amps<br>BEC 9V /12V output: <br>Designed for Video Transmitter, Camera, Gimbal .<br>Continuous current: 2 Amps<br>12V option with Jumper pad<br>for stable 9V/12V output, input voltage should output voltage +1V<br>BEC Vx output: <br>Designed for Servos<br>Voltage adjustable, 5V Default, 6V or 7.2V options<br>Continuous current: 5 Amps, 6A <br>for stable Vx output, input voltage should Vx voltage +1V<br>FC Firmware: <br>: MatekF405-Wing (ArduPlane 4.4 or newer)<br>INAV: MATEKF405SE (INAV 6.0 or newer)<br>BEC 3.3V output: <br>Designed for external 3.3V peripherals<br>Linear Regulator<br>Continuous current: 200mA<br>BEC Vx output: <br>Designed for Servos<br>Voltage adjustable, 5V Default, 6V or 7.2V options<br>Continuous current: 5 Amps, 6A <br>for stable Vx output, input voltage should Vx voltage +1V<br>Material: composite materials<br>colour: Blue<br><br>Package Contents: <br>1 x Flight Controller<br><br>Only the above package content, other products are not included.<br>Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.