1The floor electrical socket has a multifunctional 3 hole, computer and telephone interface, and has strong practicability. 2The panel is made of aluminum alloy, which is light and corrosion resistant, not easy to wear and deform. 3The bottom box is made of flame retardant PC material, which has good insulation effect and can prevent disconnection and leakage. 4Embedded installation can save space, and the wires are not exposed, reducing the trouble of desktop wiring. 5With firm and tight switch buckle, the number of switches has been strictly tested, is safe and durable. Item Type: Floor Electrical Socket Panel Material: Aluminum alloy Bottom Box and Functional Parts Material: Flame retardant PC Rated Voltage: 250V Rated Current: 13A Protection Level: IP40 Installation Method: Embedded Computer Interface: CAT5e Telephone Interface: CAT3 Use Scenes: Office desk, floor, business office building, residence, factory Panel Size: Approx. 226 x 118 x 3mm / 8.9 x 4.6 x 0.1in Bottom Box Size: Approx. 223 x 108 x 70mm / 8.8 x 4.3 x 2.8in 1 x Bottom Box 1 x Socket Panel 1 x Connector 2 x Cable Tie 6 x Mounting Screws 1. Be careful not to allow water to enter during installation, try to keep the desktop socket dry and clean to avoid potential safety hazards when using it in the future.2. Be sure to ground the wire when installing the desktop socket, so as to better protect the safety and service life issues.3. When installing the desktop socket, you must pay attention to the position, and it should not affect the normal use of the table. It is best to install it in a relatively clandestine place or a location that is not frequently used.4. After the desktop sockets are installed, be sure to test them one by one to see if they can be used normally. At the same time, pay attention to waterproof and moisture proof measures to avoid affecting future use.