BPI-R4-NIC-BE14 is a 51x82mm WiFi7 module with MediaTek MT7995AV supports Wi-Fi7 technology and feature IEEE802.11a/b/g/n/ac/ax/be compliant,2.4GHz 2x2, 5GHz 3x3 3ss, and 6GHz 3x3 3ss BE13500 Wi-Fi subsystem. The MT7995AV offers feature-rich wireless connectivity at high standards and delivers reliable, cost-effective throughput from an extended distance.The optimized Wi-Fi baseband algorithms provide superb performance. The intelligent MAC design deploys a highly efficient offload engine and hardware data processing accelerators, which fully offload Wi-Fi task of the host processor. The MT7995AV is designed to support standard-based features in the areas of security, quality of service, and international regulations, giving end users the greatest performance at any time and in any circumstances.MediaTek MT7995AV chipset32-bit RISC-V MCU for Wi-Fi protocols and Wi-Fi offloadEmbedded SRAM and ROM UART interface with hardware flow control2 PCIe 3.0 Interface, 2-laneWLAN:IEEE 802.11 a/b/g/n/ac/ax/be compliantTr-Band Triple Concurrent (TBTC)PHY rate :up to 13700 Mbps/9500 MbpsMU-MIMO TX and RXMU-OFDMA TX and RXSTBC, LDPC, TX beamformer and RX beamformeeGreenfield mode, mixed mode, and legacy modeSecurity: WFA WPA, WPA2, WPA3 personal, WPS2.0QoS: WFA WMM and WMM-PSHow to useYou can insert the BPI-R4-NIC into CN12 and CN14 at the bottom of BPI-R4-Main, and then fix it with two M2 screws.The BPI-R4-NIC module requires 12V power supply, so the power supply on the BPI-R4-Main must be turned on before powering on (SW4 is turned to the "ON" position, and the 12V LED will lights up when power on)Tips:The 12V power supply will be supplied to the BPI-R4-NIC through PIN6/28/48 of the miniPCI socket. When plugging in other modules, be sure to turn off SW4 if you cannot confirm whether the module can withstand 12V.Note: The board factory labels are slightly d