The T-connector is used to install and connect to the main line to add a branch line connection. The standard T-connector can also be attached with a cover to temporarily protect the connector for connection of diagnostic instruments. The T-connector can be matched with all other devices on that use the same type of connector. instrument network to interconnect marine electronic devices. It is multi-master and self configuring, and there is no central network controller. Equipment designed to this standard have the ability to share data, including commands and status with other compatible equipment over a single channel. It is based on CAN (Controller Area Network) One NMEA 2000 T-Connector for every device and accessories that are connected to One NMEA 2000 T-Connector for the NMEA 2000 Power Cable One NMEA 2000 Drop (Backbone) cable (no longer than 20 feet) that connect each device or accessory to its own T-connector Note: Installation guide not included, Please check as much as possible to make sure the item is what you need. Tips: The product may be updated constantly ,Due To Different Batches, The Actual Product May Have Slight Differences Or Color Differences, Which Does Not Affect Use Color: As shown Material: plastic Package Contents: 1 * NMEA2000 Connector Only the above package content, other products are not included. Note: Light reflection and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.