Details: *100% brand new and high quality*Suitable for using in welding, electronics maintenance, vehicle repairing, etc.*Material: Plastic + Aluminum*Capacity: 12ml*Flame Temperature: 1300degree Celsius*Ironing Temperature: 450degree Celsius*Use fuel: butane *Accessories: solder head, cutting head, open flame head, hot air headHow to Fill Gas:1. Confirm that the switch is at OFF, then add it.2. The tank can be imported into the air hole and compressed under the pressure.3. About 10 seconds, filling can be completed. Wait a few minutes, let the stable, and then use.4. If the is filled, the tail has a "hissing" sound, press the tip of the pen slightly into the air hole, it can be eliminatedHow to Use:1. Push the switch to the ON position and hear the sound of 'click'.2. Use an igniter or lighter, near the joint ignition.3. Burn for 3 minutes after ignition and wait for the fire to extinguish. The iron head will continue to heat up.4. Adjust the size of the flame, to the 'ten' direction is large, to the 'one' direction is small.5. Temperature is up to 1300 degrees (iron temperature 450 degrees), the use of safety should be taken, after the use of the switch closed to the OFF position.6. When using the soldering iron, pay special attention to wait until the flame is completely eliminated. When the object inside the soldering iron turns red, operate it again.7. The length of the flame is about 1.2-2.2 cm.Precautions:1.Replace the joint after cooling or replace it in advance.2.The soldering iron tip in use is hot and hot.Do not touch it with your hands.3.The adjusting button can control the gas output and temperature, usually in the middle position4.After use, store it after cooling. Do not put it in high temperature or direct sunlight.5.It is not suitable for children to use. It must be placed properly when collecting.6.Please use high quality can gas filling, and keep away from the fire source when filling.7.Because there are some impu