1、Wireless left and right gamepads can be simply connected to the console or wirelessly connected. 2、Can be used independently in each hand, can also attach to main console for use in handheld mode 3、Or it can be shared with friends to enjoy two player action in supported games. 4、Each controller comes with a full set of buttons, which can act as an independent controller. 5、Each button contains an accelerometer and gyroscope sensor, making independent left and right motion control possible. Item Type: Left Right Gamepad Material: ABS Battery Capacity: 300 mAh Charging Current: ≤ 350mA hour Charging Time: About 1 hour How to pair the controller to NSW for the first time: 1. The NSW host must be in the power-on state. If the host is in the dormant or power-off state, the controller cannot be paired 2. When the controller cannot be awakened or the LED indicator continues to flash slowly, please charge your controller before using it for the first connection and pairing, please refer to the following steps: 1. Turn on the host 2. Install the controller on the host Use the slide on the side of the main unit to slide the controller from top to bottom until you hear a soft click 3. The controller starts to automatically register and pair. After the pairing is successful, it can be plugged into the host for use, or it can be removed and connected via Bluetooth. After controller is installed on host, the pairing cannot be registered, please refer to following methods to check pairing problem: 1. Make sure your host has been upgraded to the latest system 2.Press the pairing button to close the controller, reset the connection, and then plug the controller into the host 3. Insert the controller into the host, make sure that the direction of insertion is correct, it slides to the end, and a slight click sound is heard 4. Unplug controller from the host, try to insert it again, and rule out that it cannot be paired because there is no good contact 5. If the controller cannot be awakened, please charge your controller before trying to pair How to pair (connect back) controller to NSW again: After the handle is paired for the first time, you can connect the handle to the host again in the following two ways Method 1: Bluetooth connection and pairing 1. Turn on the host 2. Press any function key (except the joystick) for 2 seconds to wake up the handle, and then the handle will automatically pair with the host via Bluetooth, and the pairing can be completed in about 4 seconds 3. Once the pairing is successful, the corresponding LED indicator of the handle will be on Method 2: Wired connection and pairing 1. Turn on the host 2. Install the handle on the host through the slide on the side of the host 3. After that, the handle will automatically pair with the host via a wired connection, and the pairing can be completed in about 4 seconds. 2 x Gamepad 1 x Charging Cable 1 x Manual