[Simple to Use]: The temperature range for this temperature controller is -40°C to 110°C. Easy to set and adjust, with HD LCD display and 4 buttons. It is a relay-based temperature controller; an external power supply is required for the load. [High Current 30A Relay]: Rated for 220V AC, 30A. Suitable for high-power equipment such as refrigerators, brooders, incubators, fermenters, and greenhouses. Connect the power supply and heating/cooling device, place the sensor, and set the desired temperature — it operates reliably. [Heating/Cooling Function]: Heating Mode ('H'): When the measured temperature is less than or equal to the set temperature minus hysteresis, the relay activates and the heating device turns on. When the measured temperature rises to or above the set temperature, the relay deactivates and the heating device turns off. Cooling Mode ('C') operates on the same principle. [Delay Start & Temperature Correction Function]: Delay Start ('OPH'): After completing a heating or cooling cycle, the system begins timing ('T'). Once 'T' reaches or exceeds the OPH value, the next heating or cooling cycle starts. Temperature Correction ('OFE', adjustable from -10.0°C to +10.0°C): Compensates for long-term measurement drift. Actual temperature = measured temperature + correction value. [High-Temperature Alarm Function]: If the actual temperature reaches or exceeds the alarm threshold, the system triggers audible and visual alarms and cuts off the relay output. Press any button to silence the alarm. Usage Steps: 1. Connect the sensor to the controller. 2. Connect power supply to the controller. 3. Set start temperature, stop temperature, and temperature correction. 4. Disconnect power supply. 5. Connect the load (heating/cooling device) to the relay output terminals, ensuring proper power supply connection. 6. Reconnect power supply to the controller. 7. Test and begin operation. Color: As shown Material: Plastic Package Contents: 1 x XY-DT01 Digital Temperature Controller Note: Other accessories are not included. Note: Color appearance may vary slightly due to lighting and screen settings. Measurement tolerance: ±1–3 cm.