1、PREVENT INTERFERENCE: The camera module is rearranged, the layout is optimized, and the interference of signal wiring is reduced. 2、FILTER CAPACITOR: Increase the filter capacitor of the sensor power supply to make the noise more delicate and the low light effect better. 3、ADD REVERSE CONNECTION: Add reverse connection to the power input end of the camera module to protect the diode. 4、INCREASE ESD ON THE POWER SUPPLY SIDE: Increase ESD on the power supply side of the vehicle camera module to protect the device. 5、ADD ESD TO THE VIDEO END: Add ESD to the video output end of the car camera module to protect the device. Item Type: Camera Module Material: PCB Sensor: 1.3 Million Pixels 1/3' for SONY IMX225 CMOS Sensor Processor: for NEXTCHIP NVP2431H Minimum Illumination: 0.01 LX at F1. 2 Effective Pixels: 1280(H) x 960(V) Frame Rate: 25fps 30fps Video Amplitude: 1.0VPP Exposure Mode: Progressive Exposure Day and Night Mode: Full Color Without Ircut White Balance: Auto White Balance Video Signal: AHD Noise Reduction: 3D Noise Reduction Working Temperature: -20 to 70℃ Power On and Power Off Test: 500 Times Interval, No Crash and No Abnormal Picture in 2s 1 x Camera Module