1. Load the battery before use and check whether the wires in the container have contact with the metal mesh, which is the key inspection step;2. Put in the grass powder. It is suggested that the length of the grass powder is more than 5mm, which is more effective.Then tighten the lid.3. In the target model and on the ground table, white latex is drawn and applied evenly, ready to start sprinkling grass powder;4. Press the surface of the target platform with the negative electrode electrical connector, as close as possible, and then use the grass planter to start spraying the grass powder 2-3cm from the target platform.5. After the grass powder is finished, pour out the extra grass powder or use a model vacuum cleaner to suck it up.Trim the haystack with small scissors and a toothpick until it grows evenly.Material:plasticcolour:blackPackage Contents:1 x Flocking Machine(Without battery)1 x Net1 Pack x Grass1 x brush1 x Planting Template ToolOnly the above package content, other products are not included.Note: Light and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.