Features 1.9‑axis motion tracking MEMS device, designed for low power consumption, low cost and high performance requirements of consumer electronic devices (including smartphones, tablets and wearable sensors). 2.This module board allows you to easily use InvenSense MPU-9150 for prototyping by decomposing all the pins you need into standard 0.1in pitch headers. 3.The board also provides I2C pull‑up resistors and a solder jumper to switch the device's I2C address. 4.The 6‑axis MotionFusion algorithm integrated in the part can access all internal sensors to collect a full set of sensor data. 5.Suitable for operation learning and development of college students, engineers, technicians, factories, individual DIY, electronic enthusiasts, etc. Specification Condition: 100% Brand New Item Type: MPU-9150 Sensor Module Material: Printed Circuit Board Purpose: Suitable for operation learning and development of college students, engineers, technicians, factories, individual DIY, electronic enthusiasts, etc. Sensor Includes: Three-axis gyroscope + three-axis acceleration + three-axis magnetic field Power Supply: 3-5v (internal low dropout voltage regulator) Communication Method: Standard IIC communication protocol Chip Built-In: 16bit AD converter, 16-bit data output (magnetic field 13-bit) Gyroscope Range: ±250/500/1000/2000°/s Acceleration Range: ±2/±4/±8/±16g Magnetic Field Range: ±1200uT Pin Spacing: Approx. 2.54mm / 0.1in Package List 1 x Module 1 x Pin Header