Adblue OBD2 Emulator for Trucks Adblue DEF and NOX Emulator Plug and Drive Ready Device by OBD2 Top 5 Reasons to Get Adblue OBD2 Emulator for Trucks: 1. ADBlue OBD2 is very easy to install. Just plug it into the OBD2 connector of truck or bus and remove the fuses mentioned. 2. ADBlue OBD2 will simulate ADBlue system functionality, supporting proper operation without requiring adBlue fluid and managing NOx sensor signals. 3. Operates without engine power loss or dashboard warnings, and maintains compatibility with diagnostic systems. 4. ADBlue OBD2 does not damage the engine and does not cause adverse effects to factory settings. 5. ADBlue OBD2 does not permanently alter any system settings. To restore original configuration, simply unplug the device from the OBD2 port. Adblue OBD2 Emulator for Trucks is a Plug & Drive Ready device designed to support adBlue system simulation and NOx sensor operation on trucks equipped with EURO 4/5/6 emission systems, including those with non-functional adBlue SCR components. Adblue OBD2 is easy to install. Installation and Calibration for Trucks: 1. Remove the key from the ignition. 2. Remove the following fuses: Terminal - 15, Terminal - 30 3. Plug Adblue OBD2 into the OBD2 connector 4. Turn on the ignition and check the adBlue level; if it shows 50% or 70%, proceed accordingly. 5. If any fault light appears on the dashboard, clear it using a service scanner. Material: Plastic Color: As shown Package Contents: 1 x adBlue OBD2 Emulator Box Interface Only the above package content, other products are not included. Note: Lighting and different displays may cause the color of the item in the picture to vary slightly from the real thing. The measurement allowed error is +/- 1-3 cm.