PD132 Single Channel Inductive Vehicle Loop Detector For The Car Parking Lot Features: The Vehicle Loop Detector is mainly used to detect the existence and passing of vehicles Reset Switch: The reset switch enables the detector to be manually reset during commissioning and testing. This results in the detector re-tuning the sensing loop and becoming ready for vehicle detection Selectable Pulse Time: This feature sets the length of time that the pulse relay will be energized for 1 Second or 0.5 Seconds Pulse Relay Selection: The Pulse Relay may be configured to energize on detection of a vehicle or when the vehicle leaves the loop Sensitivity Boost : This feature sets the undetected level to maximum sensitivity and is used  to prevent loss of detection of high-bed vehicles Switch Selectable Sensibility: 4 sensitivity setting are available on the switches to allow flexibility in configuration Switch Selectable Frequency: 4 frequency settings are available to prevent cross-talk between adjacent loops Filter Option: This option is used to provide a delay between detection of the vehicle and switching of the output relay . This relay is normally used to prevent false detection of small or fast moving objects Specifications: Supply voltage 220VAC Power 4.5VA Output relays 240V/5A Operating temperature -20~65°C Storage temperature -40~85°C Frequency range 20 kHz to 170 kHz Temperature compensation 50°C/ h Reaction time 10ms Signal holding time Unlimited/limited Sensitivity Higher:0.02% high:0.05% low:0.1% lower:0.5% Loop inductance Total loop plus connection wiring: 50μH to 1000μH. Ideal is 100μH to 300μH Loop connection wiring 200 meters long. The total resistance is less than 80hm, twisted at least 20 times per meter Relative humidity <90%No condensation Weight 283g Package included: 1 x Vehicle Loop Detector 1 x Manual Note: Please note that the new type and old type of this product will be sent randomly, and make sure you will not mind before ordering.