Power Drill Nibbler 360 Degree Adjustable Nibbler Metal Sheet Cut Double Head With Wrench Parts Silver or Orange Drill AttachmentScope of application: 160A metal sheet cutterSpecifications: There are two cutter heads for adjustable head cutting, and the cutter head can be positioned 360 degrees in any direction. Optional 8mm electric or pneumatic drill, speed 1500-3000rpm Minimum cutting radius: 12mmAllow cutting thickness: Ordinary steel plate: 1.8 mm Stainless steel plate: 1.2 mm CopperAluminum plate: 2mm PlasticFiberboard: 2mmIron box size: 18.5x11x5cm Weight: about 760g Instructions for use1 When using the thin plate hole opener, first insert the front end of the drill and the cutter into the round hole of the hole opener, connect the cutter to the electric drill and lock it, then put the three branches on the shelf, the stigma screw Tightly, to prevent the hole opener from sliding insert the left and right positioning pins upward into the small square hole of the shelf, and finally adjust and tighten the tight screw according to the size of the arc to be cut. Fix firmly to ensure the accuracy of cutting round holes.2 When cutting the standard arc, the thin-plate hole opener should be used to ensure the smooth and beautiful circular cut surface. It should also drill a 3 mm positioning eye first, and then drill a 12 mm hole to extend the cutter head. The inner and outer circles are cut inside. Operational requirements1. It is especially important to refuel at the blade edge, especially for cutting aluminum plates.2. After opening the electric drill, the cutting will be started first and then the electric drill will be closed.3. The cutting edge of the shank must be perpendicular to the workpiece to be cut during cutting to prevent the shank from breaking.