Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

RM649.00
FREE Shipping

Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

  • Brand: Unbranded

Screen Vector Network Analyzer LCD 50KHz-1.5GHz USB 5V 200mA Antenna Analyzer Shortwave VHF UHF Measure Duplexer Filter

  • Brand: Unbranded
Price: RM649.00
Sold by:
RM649.00
FREE Shipping

In stock

We accept the following payment methods

Description

["brand new and high quality\nFeatures:\n4-inch full-view LCD screen, with added for DC dimming, can be seen more clearly when used outdoors. Indoor use is more comfortable.\nThe bridge has been optimized to make full use of the harmonics of Si5351, and the 5th harmonic can now be used to measure up to 1.5GHz.\nWhen the fundamental wave is used, the CH0 output level is increased to 0dBm, and the reflection measurement is more accurate.\nThe previous abnormality of Nanovna-H near 6MHz was resolved.\nReproduce the design of the power management circuit, further reduces power supply noise, reduces USB power supply interference, reduces charging current, and protects the battery.\nOptimized PCB layout, accommodating 1950mAh battery, used for more than 8 hours.\nUART interface is reserved to facilitate DIY expansion.\nLightweight ABS housing provides good for protection for the device.\n\nSpecification:\nMeasurement Frequency: 50KHz~1.5GHz\nRF Output: 0dbm (±2dB, fundamental wave)\nFrequency Accuracy: <2ppm\nFrequency Stability: <0.5ppm\nMeasurement Range: 70dB (50kHz-300 MHz), 60dB (300M-900MHz), 40dB (0.9G-1.5GHz) enable expansion firmware)\n(Note: Please pay attention to the error caused by nonlinear transformation of the fundamental wave when using harmonic measurement.)\nPort SWR: <1.1\nDisplay: 4in TFT (320 x 480)\nUSB Interface: USB type-C Communication Mode: CDC (serial)\nPower Supply: USB 5V 200mA, Built-in 1950mAh battery, Maximum charging current 1A\nNumber of Calibration Points: 101 (fixed)\nNumber of Scanning Points: 101 (fixed)\nDisplay Tracking: 4, Marking: 4, Save Setting: 5\nMeasurement of S-parameters, voltage standing wave ratio, phase, delay, Smith chart, for time domain analysis, et\nMaterials: Metal+ABS\nPackage Size: app.24x14x3cm/9.45x5.51x1.18in\nColor: As pictures shown\nQuantity: 1set\n\nNote:\nPlease allow 0-1cm error due to manual measurement. pls make sure you do not mind before you bid.\nDue to the difference between different monitors, the picture may not reflect the actual color of the item. Thank you!\n\nPackage includes:\n1 x NanoVNA Main Unit(Including 4 inch for touch screen, 1950mAh battery)\n2 x 15cm SMA Male to Male RG316 RF Cables\n1 x SMA Female to Female Connector\n1 x SMA Simple Calibration Kit SHORT\n1 x SMA Simple Calibration Kit OPEN\n1 x SMA Simple Calibration Kit LOAD\n1 x USB Type-C Data Cable\n1 x Type-C to Type-C Cable(other accessories demo in the picture is not included.)"]
  • Fruugo ID: 369484712-800587472
  • EAN: 7927015236138

Delivery & Returns

Dispatched within 24 hours

  • STANDARD: FREE - Delivery between Fri 03 October 2025–Wed 08 October 2025 - FREE

Shipping from China.

We do our best to ensure that the products that you order are delivered to you in full and according to your specifications. However, should you receive an incomplete order, or items different from the ones you ordered, or there is some other reason why you are not satisfied with the order, you may return the order, or any products included in the order, and receive a full refund for the items. View full return policy

Product Compliance Details

Please see the compliance information specific to this product outlined below.

The following information is provided by the independent third-party retailer selling this product.

Manufacturer
The following information outlines the contact details for the manufacturer of the relevant product sold on Fruugo.

  • Shenzhen Yiyuxun Hardware Tools Co., Ltd.
  • Shenzhen Yiyuxun Hardware Tools Co., Ltd.
  • Room 205, Building D10, No. 5, Cengyao Industrial Zone, Yulv Community
  • Yutang Street, Guangming District
  • Shenzhen
  • China
  • 518000
  • cyjeniaunr@163.com

Responsible Person in the EU
The following information outlines the contact information for the responsible person in the EU. The responsible person is the designated economic operator based in the EU who is responsible for the compliance obligations relating to the relevant product sold into the European Union.

  • Yating He
  • E-CrossStu GmbH
  • 69 Mainzer Landstrasse
  • Frankfurt am Main
  • Germany
  • 60329
  • E-crossstu@web.de
  • +4969332967674