Upgrade: Low cost and high stability, can replace the basic program of STM32F103C6T6 chip. (If your program flash is less than 32KB, RAM is less than 10KB, and Timer 4 and Serial 3 are not used, it can be used as a replacement) ST-Link V2 Programmer: Supports a full range of STM32 SWD debugging interfaces, simple 4-wire interface (including power supply), fast and stable; interface definition marked directly on the shell 40-pin STM32F103C6T6 minimum system board: Micro-USB connector for board power and communication Added 5V power output, output I/O port protected to prevent damage to ST-Link V2 due to operational errors Color: Random color, no specific color selection available Material: Plastic + Metal Package Contents: 1 x STM32F103C6T6 development board (unwelded pin header) 1 x ST-Link V2 downloader (random color, no specific color selection available) 1 x cable (random color, no specific color selection available) Only the above package content, other items not included Note: Lighting and display differences may cause slight color variations between the image and actual item. Measurement error allowed within +/- 1-3 cm