Precise end cuts - A plate is placed against the flat section of the measuring device and the full assembly (miter gauge and board) is pushed forward so that the end of the board is cut exactly at the prescribed position. - Benefit: repeatable, accurate cuts with minimal setup and reduced waste. Pivoting crescent piece - A crescent-shaped piece is attached to the guide and can pivot at its connection point to the guide. - Benefit: flexible alignment for different cut lines and workpiece edges. Well-designed miter gauge fence - The miter gauge fence is carefully designed to support reliable woodworking. - Benefit: improves accuracy and consistency for each cut, making it an essential table accessory. Durable construction - Made of aluminum alloy for strength and stability. - Benefit: robust performance and long-term reliability in the workshop. Compatibility and use - Designed to work with the flat section of the measuring device and the associated guide and fence on standard table setups. - Benefit: versatile, practical accessory that integrates with common table/workbench configurations. Use scenarios - Scenario 1: End trimming for picture frames, cabinetry, or shelving where exact end lengths are required for a clean fit. - Scenario 2: Reproducing identical parts across a project by using the plate and fence to position each cut at the same preset location. - Scenario 3: General table work in a small shop, providing a stable, precise guide for safe crosscuts on various boards and edge conditions.