CC2531 Zigbee Emulator CC Debugger USB Programmer CC2531 Sniffer Outputs 8 IO ports and debug pins. Combined firmware enables analysis functionality. The DC debugger is a compact programmer and debugger designed for low-power RF systems. It is compatible with the IAR Embedded Workbench for 8051 (version 7.51A or later) for debugging, as well as the SmartRF Flash Programmer for flash programming. The DC debugger can also be used to control SmartRF Studio devices. Includes: - DC debugger - 10-pin flat cable with 2.54mm connector The DC debugger supports programming and debugging of the following 8051-based systems: CC1110, CC1111 CC2430, CC2431 CC2510, CC2511 CC2530, CC2531, CC2533 CC2543, CC2544, CC2545 It also enables control of these devices via SmartRF Studio. Additional supported SmartRF Studio transmitters: CC1120, CC1121, CC1125, CC1175 CC1100, CC1101, CC110L, CC113L, CC115L CC2500, CC2520 Compatible with PurePath wireless devices: CC8520, CC8521 CC8530, CC8531 The DC debugger is compatible with IAR EW8051 version 7.51A or later. Product Introduction: Operating Frequency: 2.405–2.485 GHz Wireless Transmission Rate: 250 Kbaud Power Consumption: Less than 20 mA (receiving), less than 25 mA (transmitting) Color: Black Material: Plastic Package Contents: 1 x CC2531 Sniffer Board with Antenna 1 x Programmer Download Cable 1 x CC Debugger Note: The package includes only the items listed above. Other products are not included. Lighting and display differences may cause slight variations in color between the image and the actual item. Permissible measurement error: ±1–3 cm.